USB Smart Bike Light Computer Front Bike Handlebar Bicycle Lamp MTB Cycling Computer Stopwatch with Horn Function
Item:USB Rechargeable Bike Light with Computer and Horn
Battery: rechargeable 1500 mAh lithium battery
Lamp beads: T6 lamp beads
Waterproof: Water resistant
Strong / Low / SOS / Yellow Warning Light
Endurance: 3-5 hours
Charging time: 2 hours
Light brightness: 250lm
Display: Speed / ODO / DST / Riding time / Average speed
Features: Suitable for urban optical design, smart battery display, head sensor code table, five modes can be changed, 38cm long split remote control, daily waterproof, large capacity built-in lithium battery, sliding rubber base
1. After power-on for 2 seconds, the upper part is the current battery level display, and the lower part is the code table unit setting. The default is metric unit (Km/h).
2. Press the MODE button once to switch to the English unit.
3. Press the MODE button and the SET button simultaneously for 5 seconds, the system enters the soft start, and all the settings are cleared. The system is the same as the new power-on.
4. After setting, press the MODE button to determine the speed unit.
5. At this time, the default tire circumference is displayed. Press the MODE button. The tire is increased once. The unit is cm. The setting range is 10cm-315cm.
6. After setting, press SET to enter the initial total mileage setting.
7. At this time, there are 5 numbers on the display. The first one is flashing. Press the MODE button and the value will increase.
8. After setting the first digit, press the SET button. At this time, the second digit flashes and press the MODE button.
9. After setting the fifth digit in turn, press the SET button to exit the initial total mileage setting.
10. After setting the tire circumference and total mileage, enter the standby state. At this time, press the MODE button, km/h flashes, the system automatically accelerates and decelerates.
11. The system displays the acceleration symbol (▲) when accelerating, and the deceleration symbol (▼) when decelerating.
12. When km/h does not flash, the system does not display the symbol during acceleration/deceleration.
13. After the system enters the standby state, there is no button cargo speed signal within 5 minutes, the system enters the sleep system. When the system is in sleep, the MODE button or SET button is triggered, and the system enters standby mode.
1 x Smart Bike Light
1 x Code Table-Data Receiver
1 x Speaker Control
1 x Code Table-Data Sensor
2 x Gasket